Once the disabled vehicle has been started, run both engines for an additional three minutes before disconnecting the jumper cables. The purpose of these head restraints is to help limit head motion in the event of a rear collision. Do not let the reservoir for the master cylinder run dry, this may cause the brakes to fail. Washing your vehicle Wash your vehicle regularly with cold or lukewarm water. All vehicles built for sale in Canada include a tether anchor hardware kit.
Replacing license plate lamp bulbs For bulb replacement, see a dealer or qualified technician. Use tar remover to remove any tar spots. Press to move the front portion of the seat cushion up or down. Press to move the rear portion of the seat cushion up or down. Do not start your engine with the air cleaner removed and do not remove it while the engine is running. Vintage Motor Cars is not an expert in the construction, metallurgy, engineering, finishes, materials, and componentry of every single vehicle ever made. To return to normal overdrive mode, press the Transmission Control Switch again.
Repairing paint chips Minor scratches or paint damage from road debris may be repaired with touch-up paint, repair foil or aerosol paint spray from the Ford accessory line. Rewind The rewind control works in tape mode. Remove headlamp by taking the retainer pins out. If a light fails to illuminate, have the vehicle serviced. Failure to do so may cause objects to fall out of the trunk or block rear view vision. Batteries contain sulfuric acid which burns skin, eyes, and clothing. Some manuals actually cover more items that are not even listed! Recycled engine coolant Ford Motor Company recommends that Ford and Lincoln-Mercury dealers use recycled engine coolant produced by Ford-approved processes.
After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. To release the parking brake: 1. Always replace the cover to the Power Distribution Box before reconnecting the. To unfasten, push the red release button and remove the tongue from the buckle. Connect the negative - cable to the negative - terminal of the assisting battery. An explosion could result in injury or vehicle damage. Starting autoset memory preset 1.
Turn the blade at an angle from the wiper arm. Turn the blade at an angle from the wiper arm. Keep a record for at least one month and record the type of driving city or highway. It should not be necessary to add any aftermarket products to your fuel tank if you continue to use a high-quality fuel. Call your local recycling center to find out more about recycling automotive batteries. Recycled engine coolant Ford Motor Company recommends that Ford and Lincoln-Mercury dealers use recycled engine coolant produced by Ford-approved processes.
Otherwise, the display will not show the addition of fuel for a few kilometers miles. To lengthen the belt, turn the tongue at a right angle to the belt and pull across your lap until it reaches the buckle. Turn the headlamps on and make sure they work properly. When washing: Take care when using a power washer to clean the engine. Press and release the HomeLink button a second time to complete the training process. Push the lock pin with a screwdriver to release the blade and pull the wiper blade down toward the windshield to remove it from the arm.
Remove the center ornament from the aluminum wheel with the tapered end of the wheel nut wrench that came with your vehicle. It is visible when viewed from the above rear of the headlamp. Refer to the scheduled maintenance guide for scheduled maintenance. Tune adjust in radio mode Press to move to the next frequency down the band whether or not a listenable station is located there. Add 118 ml 4 oz. Start the engine of the disabled vehicle.
A stronger signal may temporarily overtake a weaker signal and play while the weak station frequency is displayed. The master key will actuate doors, trunk, glove box, ignition and remote trunk release. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Use glass cleaner or tar remover if necessary. Once the engine has been started, run both vehicles for a further three minutes before disconnecting the leads. If the retractor is not locked, unbuckle the belt and repeat steps two through nine. Safety belt warning light and indicator chime The seat belt warning light illuminates in the instrument cluster and a chime sounds to.
To fasten, insert the tongue into the slot in the buckle. For information on the safety belt warning chime, refer to the Seating and safety restraints chapter. The Town Car discontinued use of the Windsor-series engines in 1991 with the introduction of the 4. Indicates vehicle information related to recycling and other environmental concerns will follow. The battery saver will shut off the interior lamps 30 minutes after the last door is closed.