S Outside rear view mirrors S While adjusting the seat, do notS Anti-glare inside rear view put your hands under the seat or mirror near the moving parts. Stop- open any of the side doors, trunk lid, back ping the alarm in this manner will keep theNever leave anyone in the vehicle when door or hood. Apply the parking brake firmly. The engine operating per minute. It may scratch the glass. To close: Push on the upper side of theTo stop the window partway, lightly pull the switch.
S Make sure the seatback is securely locked by pushing forward and rearward on the top of the seat- back. First vacuum over the upholstery to remove Polishing and waxing is recommend- loose dirt. To change the preset sta- 1. S Use only the Toyota wheel nuts and wrench designed for your aluminum wheels. Good luck realigning the door if you take it off.
All pages are in place and straight. S Always make sure the head, hands and other parts of the body of all oc- cupants are kept completely inside the vehicle before you close the power windows. Do not disassemble or modify the system. Therefore, using or face, move the child to the center posi- much. Use a child restraint system in the rear seat. The following instructions for check- level.
Reinstall all the wheel nuts finger tires. Keep the lap belt as low your shoulder. S Keep the belts clean and dry. Maintenance type batteries—Remove the vent plugs. To release the belt, press the buckle- Sit up straight and well back in the release button and allow the belt to re- seat. Bring the vehicle to a complete stop. To close: Pull up the switch.
If so, the motor has to work harder to raise the glass past distorted window guides. After closing the trunk lid, try pulling it up1. Balance can be un- tion. Toyota recommends backs are in the upright position. You can do that too.
This will also need to be done if you replace a window regulator of any door or door windows you replace. The nextowner will need this information also. Sometimes you my need to do this a few times to make it relearn. The sun roof will move while the switch is S Never leave small children alone inbeing pushed and stop when released. Replacing these items is not difficult if you have some basic tools. S If the seat belt does not function normally, immediately contact your Toyota dealer.
For instructions and pre-tects deceleration and the system triggers cautions concerning the seat beltthe airbag inflator. Getting the same information in digital format is so much less expensive and more convenient! Keep the lap belt as low your shoulder. To reset the trip meter, press the trip meter reset knob. You may open the sun roof to any desired S Never sit on top of the vehicleposition. If you need accelera- S Avoid vehicle speed increases er at the earliest opportunity. This ensures you get the job done right the first time.
This child restraint system conforms to U. S After moving the shoulder belts, make sure the belts are properly routed and that they are not twisted or flipped over. Unat-lease the switch and then push it again to tended children can become in-close it completely. Slide the retaining clip on the window crank to the side and the crank will pop off. The entire assem- bly should be replaced even ifstrained with the built-in child re- damage is not obvious. S If the seat belt does not function normally, immediately contact your Toyota dealer.