The adjustable head restraint It is not necessary to remove the head restraints from the seats when removing seats from the vehicle. This will prevent your vehicle from moving unexpectedly. Grasp the bulb only by its plastic base and do not touch the glass. See the detailed instructions under Safety Seats for Children in this chapter. These levers allow third-row passengers to enter and exit more easily. Remove the flat tire and replace it with the spare tire.
Gauges Fuel Gauge The fuel gauge displays approximately how much fuel you have in the fuel tank. In most states and in Canada, the law requires their use. When the two-passenger bench seat is removed from the vehicle, you must detach the single window tongue from the auxiliary buckle. An unsecured safety seat could also injure other passengers. Ford Motor Company has not developed or approved a T-hook sling-type procedure. Place your hand under the seat cushion and tip the front of the seat upward slightly.
Power Steering Fluid Check the level of the power steering fluid at least twice a year i. Writing to Ford Motor Company Canada, Limited, Service, read your Warranty Information Booklet carefully find out, about your vehicle's warranties and your basic rights, if you lose your Warranty Information Booklet, you can get new. The digital display on the radio shows the disc and track number. For less washer fluid, press the switch once and release it. Replace the wheel cover by pressing it into place. Telephone: 313 594-4857 Fax: 313 390-0804 If you are in other foreign countries, contact the nearest Ford dealership.
. Improper location of the seat will prevent correct use of the safety belts and will increase the risk of severe injury in an accident. Within three or four minutes once the engine coolant is warm enough , the fan speed gradually increases and airflow changes to the floor. As a seven-passenger vehicle, it will have either a two-passenger bench seat or two second-row bucket seats and the sliding three-passenger bench seat in the third row. When we can, we design parts that do not need to be serviced.
The lever is underneath the front of your seat. Removing the quick-release bucket seat. Temporary malfunctions may cause your Service Engine Soon light to illuminate. It is located below the radio controls. The fuel gauge indicator may vary slightly while the vehicle is in motion. Make sure the lug wrench is secured back into the tool kit and store it next to the jack. These child restraints are to be used only by children who: are at least one year old weigh between 10 and 27 kilograms 22 and 60 pounds whose shoulders are below the shoulder harness slots Children not meeting these requirements should be restrained in an approved aftermarket child safety seat.
Ford recommends the use of a child safety seat having a top tether strap. If necessary add 1 to 2 quarts of oil. Route the tether strap under the headrest and between the head restraint supports. When the cupholder is not in use, push the cupholders into the cover and lift the cover into its fully stored position. You must line up the raised circle on the back of the wheel cap with the indented area on the wheel in order to press the wheel cap on.
The rating is based on the carrying capacity of the weakest axle and suspension component as well as other factors. Slide the seat rearward to release the seat from its anchor position. Lift up on the two floor latch levers near the front seat legs and release the seat legs from each anchor position. What to do when your car battery loses charge over several days of the vehicle not being used. Ford recommends that all safety belt assemblies used in vehicles involved in a collision be replaced.
However, if the transaxle is not working properly for example, slipping or shifting slowly , or you notice some sign of fluid leakage, the fluid level should be checked. Make sure that you can breathe fresh air. Hold the tab from the lower outboard side of the child seat and lower the cushion completely. When you activate the washer, the wiper will cycle twice and then stop. Locate and remove the upper intake manifold.