Exceeding these limits will result in a blown fuse. Connect the negative battery cable. If other than Ford, Motorcraft or Ford-authorized parts are used for maintenance replacements or for service of components affecting emission control, such non-Ford parts should be equivalent to genuine. Follow the instructions on the cleaner label. Bring the vehicle to a stop. Open the liftgate to expose the lamp assemblies. Protect yourself from engine heat.
To activate the heated mirrors, press the rear defrost button located on the climate control panel. Disconnect the positive post of the battery cable. To correct this condition, remove or redistribute the payload according to the recommended requirements and follow the procedure outlined above. In general, the larger the number, the wider the tire. Ford Motor Company and Ford of Canada do not access event data recorder information without obtaining consent,. The system automatically shuts off after 10 minutes.
If it is idling rough there is probably a larger problem in play. Refer to the Scheduled Maintenance Guide for the service interval schedules. If the gauge indicates low pressure, stop the vehicle as soon as safely possible and switch off the engine immediately. Pressing the control for more than three seconds results in fast rewind. Release clutch slowly while pressing down slowly on the accelerator pedal. The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law. All of Chilton's online content for the 1999 Ford F-150 is updated monthly, so you'll have the most recent information on hand for any Do-It-Yourself project.
To avoid damaging the blades, do not use fuel, kerosene, paint thinner or other solvents. Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. They should bo … th be hot to the touch when the engine is hot. The most common heater failure on the F150 is operation of the blend door.
If you replace the fuel filter, replace it with an authorized Motorcraft part. The belt will still retract to remove any slack in the shoulder belt. F150 SuperCrew Owners: Snowplowing Your vehicle is not recommended for snowplowing. It does not cover F250, super Duty or diesel model. Several air bag system components get hot after inflation. A chime will also sound to remind you to fasten your safety belt. To order direct, call 1—888—490—6837.
Autolocks This feature automatically locks all vehicle doors when the vehicle is shifted into any gear, putting the vehicle in motion. Tighten the bolts to 15-20 ft. Remove the terminal nut and separate the battery starter cable from the starter motor. Speaker fade adjust Speaker sound can be adjusted between the front and rear speakers. Refer to Rear Window Defrost in the Climate Controls chapter for more information.
To install the bed extender, follow the removal procedure in reverse order. Loosen the clamp that secures the air filter element in place. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail. Dolby reduces the amount of hiss and static during tape playback. When driving the vehicle off road, the bed extender should be removed and the tailgate closed.
Department of Transportation-Tire quality grades: The U. Shorten and fasten the belt when not in use. If your vehicle requires professional service, your dealership can provide necessary parts and service. Let the engine idle for at least one minute. To obtain reimbursement information, U.
Department of Transportation requires Ford to give you the following information about tire grades exactly as the government has written it. The relearning process will automatically complete as you drive the vehicle. If you do not use the proper fuel cap, the pressure in the fuel tank can damage the fuel system or cause it to work improperly in a collision. Underneath the passenger side of the truck you will find the starter. Ford recommends the use of a digital or dial type tire pressure gauge rather than a stick type tire pressure gauge. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. Start the vehicle and release the parking brake.
For instructions, refer to Checking the engine oil in this chapter. Instructions are very clear and it definitely helps you to do a job quicker and cheaper. Install the bulb socket in lamp assembly by turning it clockwise. Refer to Shuffle feature for more information. The hazard flashers can be operated when the ignition is off. Another option is to check for the Haynes manual in a public library.