Note to everyone when determining and referring to left and righton a vehicle pretend you are sitting in the driver's seat andthat's how we mechanics refer to left and right when talking orordering parts. It is located inside the drivers side wheel well tucked up behind the plastic splash guard. Customers are Responsible for the Initial Shipping Cost and all Return Shipping Costs. However the dealer found a bare wire going to the number 6 injector. You will need to drain the oil and fuel from the rails. Good luck it's a little tricky but can be done in an hr or two for first timers.
Warranty will not be extended to failures caused by incorrect installation or application, modification, contamination, negligence or abuse. It's similar to the pcm connector. It's a harness that electrically controls the injectors and glo … w plugs. Their is a series of really small 5mm bolts along the crease a few 10mm bolts further inside wheel well and don't forget to remove the 2 plastic push pins underneath around the left lower corner of the door if these are not removed it makes your life much more difficult. I should do the 50 cent mod while apart? First remove valve cover on the side you are replacing.
Returned Merchandise that is Damaged Upon Receipt Will not be Credited. Is one side more likely to come loose? Install to bore making sure it's all the way down If you cant start the hold down bolt it's not all the way down If you can start the bolt it will aide in pulling down the injector tighten to spec. Their is a paper telling you where they go the pink one's a little tricky be carefull with that one. No need to remove the one by the exhaust manifold. The parts guy said it could be the driver or most likely a problem with an injector.
So it's from the front 2468 on the driver side lefthead and 1357 on the Passenger right cyl he … ad. To do this their are two plugs in the head in between the injectors. No Credits Are Issued on Shipping Costs. All Returned Items Must Be Repacked and Returned With Invoice in Their Original Packaging for Protection. The cyl head has oil and fuel in them.
If you don't all the oil and fuel in the head will go into the cyl bore when the injector is removed causing a hydro-lock condition. How easy is it replace the injectors and or the driver module? O Ya their is also an oil squirter you will need to install to the new injector its on the old one it's alumminum you can do that last after the injector is installed. Now off the the other side??? It will start and it will smoke alot Dont worry it's normal and it will clear-up. Now this is a very very important step!!!! All Returns Are Subject to a 25% Re-stocking fee. This warranty applies to product used under normal operating conditions and service.
The new injectors will need to be o'ringed just make sure they are in the right slot. . This warranty applies to product used under normal operating conditions and service. The inj have 2 hold down 8mm bolts only remove the one closes to the turbo. With the connector off you can see how it is mounted up inside. Packages being Returned Should Be Insured by you for your Protection.
Be careful the plugs can strip out easly. Make sure to put oil or trans gel on o'rings before installing into bore. The 1996 has a larger non-wastegated turbocharger, while the 1999 is wastegated. Except ofcourse good mechanics -- we know what's right. Remove all the bolts securing the splash guard. To make it easier remove the under valve cover harness. I guess I asked for that.
The warranty does not extend to diagnostic time, incidental or consequential damages. The way the injectors are fired is by oil pressure and fuel. Started my 00 Excusion this morning and it was running a bit rough. How in the heck do you get that back valve cover bolt back in? Under the driver side valve cover second one back from the front ofthe motor. Check engine light came on, drove to auto parts store to have it scanned.