Here you go Jan 06, 2012 Hello and welcome. If so, the module is located behind the left rear trim panel. Remove the rear liftgate trim panel. Install the upper liftgate garnish molding. If you have questions, please contact us before buying to avoid confusion. The engine types may include 4.
Install the cylinder lock rod into the threaded lock rod retaining clip while removing any slack from the lock rod linkage. Important: Use needle-nose pliers to slightly squeeze the C-clip back into shape. Remove the C-clip from the rear liftgate lock cylinder push button and remove the wave washer. Parts are shown individually with their own Ref , while sub-assemblies may show multiple parts within a square or circle in the diagram with its own corresponding Ref. Remove the liftgate and inspect the inner to outer panel welds at the upper hinges. Remove the upper liftgate garnish molding.
Superseded Part Numbers This item may have been superseded from a different part number from this manufacture. Torque the screws to 22 in-lb 2. The reason this may have happened is that a couple of welds may have broken around the upper liftgate hinge s or a crack may have formed around the inner two welds. The illustrations in this catalog are to be used as a guide only. All other marks are the property of their respective holders. Step 11 • Reinstall the liftgate.
Install the wave washer with the cup side up. Step 6 • Clamp the inner and outer panel together. If you have questions, please contact us before buying to avoid confusion. Vehicle Fitment Summary To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. If the clip rotates then the clip is not fully seated. Superseded Part Numbers This item may have been superseded from a different part number from this manufacture. Step 12 • Replace the upper two bumpers and inspect the lower two bumpers.
Use the key fob to cycle the liftgate to the lock and unlock position while inspecting the rear liftgate pawl. Remove the sill plate from the vehicle. The diagram above is a Genuine Factory image from the vehicle manufacturer showing the entire assembly surrounding the part or sub-assembly you are purchasing. Close the lock rod retainer clip. .
Open the liftgate glass while keeping the liftgate closed. Be sure to order for side you need. Reposition the rear liftgate lock cylinder wave washer and adjust the lock rod using the steps below. Open the liftgate glass while keeping the liftgate closed. To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. This part fits vehicles made in the following years 2002, 2003, 2004, 2005, 2006. Install the C-clip onto the shaft and in the slot using needle nose pliers.
Remove the right rear quarter trim panel. Remove the cylinder lock rod from the threaded lock rod retaining clip. Position the lock cylinder pawl to the full clockwise position. The online catalog may use one illustration to reference parts for both the left and right side of the vehicle. Correction Important: Do Not remove the rear liftgate lock cylinder from the vehicle to perform this repair.
Make sure the clip seated, you should feel a snap and hear an audible click. Step 3 • Straighten the sheet metal at the hinges. The part or sub-assembly you are buying may be referenced on a diagram above. To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. Reposition the rear liftgate lock cylinder wave washer and adjust the lock rod using the steps below. The part or sub-assembly you are buying may be referenced on a diagram above.
You can find the part or sub-assembly being sold by locating the correct Part Reference on the diagram. Step 9 • Return the surface to its original contour. Remove the panel to access. If the pawl is contacting the latch, readjust the cylinder lock rod. Remove the liftgate trim panel screw access plug. Also review the notes section in the compatibility chart for additional specifications about this part.