Then push on the power connector's retaining tab at the bottom of the connector near the wires and wiggle it until it comes free from the high beam bulb's base. Note: I am not a registered charity. To skip ahead to the instructions for the specific bulb that you need to replace, just look for the corresponding bolded number below. Test the new bulb by turning on the vehicle's high beams. When you need to replace the headlight, turning signal or parking light bulb on your 2005 Honda Accord Coupe, finding out what the replacement size you need can be a time consuming task. Passenger Low Beam Headlight Bulb - First start the engine and turn the steering wheel all the way to the left to create some working room in front of the passenger side tire. I figured if the dealer broke something then they would be paying for that.
Passenger Low Beam Headlight Bulb, 2. The ground wire is common to the high and low beam filaments, so again this is not the issue. Be sure to not touch the glass bulb on the new bulb. Locate the light blue power connector on the high beam headlight bulb's base situated just to the right of the turn signal bulb. Gently turn the bulb counter-clockwise to release it.
Test out the new driver side low beam headlight bulb before putting back the fender well and re-inserting the three black plastic pop rivets. Our Honda Accord Coupe light bulb guides allow you to easily replace light bulbs, replace headlight bulb, change a broken lightbulb, install a hid headlight conversion or install led light bulbs instead of spending countless hours trying to figure out which light bulb sizes in your 2005 Honda Accord Coupe. Test the new bulb by turning on the vehicle's high beams. Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. Once the three black plastic pop rivets are removed, pull back the fender well cover and locate the low beam headlight bulb socket.
I can normally change a headlight bulb inside of 10 min for both. The Modified Life staff has taken all its Honda Accord Coupe headlight bulb replacement guide, Honda Accord Coupe light bulb size guides, Honda Accord Coupe light bulb replacement guides and cataloged them online for use by our visitors for free. Pull the passenger side front side marker light bulb straight out from the socket and replace it with a new one. Please help support this website by shopping at. Removing the car's battery helps make the job a lot easier, but is not necessary.
Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. Try wiggling if it won't come off easily. Attach the wiring harness to the new headlight bulb. If you do touch the bulb, clean it with a paper towel and some rubbing alcohol. Check for power on both sides of fuse 6 in the underhood fuse box.
Driver Side Low Beam Headlight Bulb - To access the driver side low beam headlight bulb, first start the engine and turn the steering wheel all the way to the right. Before you can remove the driver side low beam headlight bulb, you must press down on the power connector's plastic tab at the bottom near the power wires and wiggle the connector off of the bulb's base. I even, to my amzement consulted the owners manual and the internet. This creates enough room in front of the tire to access the low-beam headlight bulbs. Always verify all light bulb sizes, bulb voltage usage and bulb wattage before applying any information found here to your 2005 Honda Accord Coupe. Test the bulb before replacing the fender well and pop rivets.
Try wiggling if it won't come off easily. Removing the car's battery helps make the job a lot easier, but is not necessary. Changing both headlight bulbs on your Accord at the same time will allow both bulbs to have the same intensity and prevent the new headlight bulb from appearing brighter than the bulb on the opposite side. Also I did think of taking out the battery for the bulb but did what the owners manual said. These bulbs have a very high voltage that runs through them, even if the battery is disconnected. Passenger Side Sidemarker Light Bulb - The passenger side marker socket is located just above and to the right of the low beam headlight behind the fender well cover. Pull it towards you, and then press the tab on the bulb socket to release the wiring harness.
Please help support this website by shopping at. Be sure to not touch the glass bulb on the new bulb. Driver Low Beam Headlight see 2 for driver sidemarker , 4. Then remove the two black plastic pop rivets along the edge of the fender well and the third one located a few inches closer to the center of the car with a small flat head screwdriver. Driver Side High Beam Headlight Bulb - The driver side high beam headlight bulb is probably the most difficult to remove since you can't see what you're doing.
Hi all, I tried to get it out by going in though the inner fender just as stated above. Replace it with a new high beam headlight bulb and test it by turning on the high beams. Push on the the tab located near the bottom of the high beam headlight bulb power connector and wiggle off the connector from the bulb's base. For more, check out my other. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal. The relay is not a common failure, also the relay feeds both side low beam lights so it is not the failure in this case.