Press the wiper control to activate the rear wiper. In order to properly diagnose and service your vehicle, Ford Motor Company, Ford of Canada, and service and repair facilities may access vehicle diagnostic information through a direct connection to your vehicle when diagnosing or servicing your vehicle. Failure to adjust the safety belt properly could reduce the effectiveness of the seat belt and increase the risk of injury in a collision. When the engine is cold, check the level of the engine coolant in the reservoir. Open the tether anchor cover.
Under engine misfire conditions, excessive exhaust temperatures could damage the catalytic converter, the fuel system, interior floor coverings or other vehicle components, possibly causing a fire. To turn on the dome lamp manually, move the panel dimmer control to the full upright position, past detent. The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law. Pull lever up to adjust seatback. To solve this I would recommend either a Haynes or Chilten service manual available from your local auto parts store. If any other door has been opened from the inside, the lamp will shut off immediately after the door is closed. Ford may change the contents without notice and without incurring obligation.
Front safety belt usage sensors The front safety belt usage sensors detect whether or not the driver and front outboard passenger safety belts are fastened. Check the fluid level on the dipstick. Use with the recirculated air to improve cooling performance and efficiency. Lift handle to move seat forward or backward. Inflate all tires to the inflation pressure recommended by Ford Motor Company. Stop the vehicle as soon as safely possible, switch off the engine and let the engine cool.
If any light remains on after starting the vehicle, have the respective system inspected immediately. Do not insert any other object in the power outlet as this will damage the outlet and blow the fuse. Remove the two outboard grommets from the inside of the decklid. The recorded information may assist in the investigation of such an event. Running out of fuel Avoid running out of fuel because this situation may have an adverse affect on powertrain components.
The indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. Push the lock pin manually to release the blade and pull the wiper blade down toward the windshield to remove it from the arm. If your vehicle is not serviced in accordance with flexible fuel vehicles procedures, damage may occur and your warranty may be invalidated. It is an integral part of the vehicle. The airbags inflate and deflate rapidly upon activation. They also have great service and very reasonable prices.
Park the vehicle on a level surface and engage the parking brake. Cell phone use The use of Mobile Communications Equipment has become increasingly important in the conduct of business and personal affairs. Visually inspect the tires to make sure there are no nails or other objects embedded that could poke a hole in the tire and cause an air leak. Ford Motor Company will repair or. See Front passenger sensing system in the airbags section of this chapter.
Lower the wheel by turning the jack handle counterclockwise. Charging system: Illuminates when the battery is not charging properly. What you really want, if I understand your question correctly, is to be able to tell what each fuse goes to. All personal codes are now erased and only the factory set 5—digit code will work. The side airbag system including the seat must be inspected and serviced by a qualified technician in accordance with the vehicle service manual. Servicing after towing If you tow a trailer for long distances, your vehicle will require more frequent service intervals.
You must distribute the load in your trailer so that 10—15% of the total weight of the trailer is on the tongue. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. These quality products have been specifically engineered to fulfill your automotive needs; they are custom designed to complement the style and appearance of your vehicle. . If you do not hold the brake pedal down, your vehicle may move unexpectedly and injure someone. At the back of the headlamp, pry up and remove the two retainer pins to release the headlamp assembly from the vehicle and pull headlamp forward. Accident statistics suggest that children are safer when properly restrained in the rear seating positions than in the front seating position.