Also noticed that there were no brake lights or turn signals working on my trailer? Vehicle overloading may increase the likelihood of a crash. The Dealer Stated That The Failure Was Due To The Electronic Control Unit. Jan 03, 2012 The Contact Owns A 2008 nissan titan. This part was recalled in the 2004-2006 Nissan Titans. The lower control link assembly has two cylindrical collars forming the inboard attachment points to the chassis. I also advised them that it took a quarter tanks of gas to go 30 miles, then the failure occured.
Mine had similar a issue and it ended up being the engine knock sensor. I Was Able To Get The Truck Back Into Normal Automatic Mode And I Had To Ride My Breaks Down The Mountain To A Flat Area And Swap Vehicles To Tow The Trailer. After speaking with them and advising that the truck died at 50 mph on me twice I asked them if they would tow, as it's not safe to drive. There Is A Recall On Certain nissan titans, But They Are Before This Model Year. Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 tty 1-800-424-9153 , or go to. Not sure what to do now.
They said to leave the truck there and a regional manager would call me by tomorrow. I just bought this used 4 months ago it is 2006. Died while i was driving then wouldnt start. No call from anyone today. This standard specifies requirements for tire selection to prevent overloading.
Thanks for posting your info on the forum! This could cause engine stalling increasing the risk of a crash. That way, I don't have to do anything right now! Meaning Using The Shift Lever To Pull The Tuck Out Of Park And Back Into Park. Owners may contact Nissan at 1-800-647-7261. The gear shifter button will not respond when the button is pressed. Dealer said nothing they could do since the truck is 2,500 miles over the emission warranty.
Called dealership next morning and they stated that there is a voluntary recall for the faulty relay. Once running, it runs perfect. This service will be performed free of charge. The safety recall is expected to begin on or about may 14, 2012. The safety recall began on March 22, 2010.
The Japanese automaker said the problem may cause the engine to stall. The safety recall is expected to begin during December 2010. New here, thanks for all threads existing and forthcoming!!! This recall will involve 179,000 cars in the U. The Ipdm Or Intelligent Power Distribution Module Failed In A Vehicle Just Over Three Years Old, With 20,000 Miles On It. The recall is expected to begin near the end of July 2008. It could cause the bushing collar to crack, leading to a rough and noisy ride.
Vehicle was not using Cruise Control. Also something is draining my batt. I just bought this used 4 months ago it is 2006. Also, the speedometer started going wacky on me now. This could cause the vehicle to run out of gas and stall on the highway, which could cause a crash.
The Contact Also Stated That The Rear Axle Failed While Driving 60 Mph And The Rear Axle Was Replaced. The brake pedal pivot pin end was not spin-formed to specification during the manufacturing process of the brake pedal assembly. Dealers will inspect the seat track assembly on the driver's and front passenger seats and replace the entire seat assembly free of charge. It runs perfect when it's not stalling and telling me I'm going 55 mph when I'm going 20 mph. The affected vehicles have a brake master cylinder which may intermittently reduce the pressure supplied to the front brakes. After This Incident I Found That This Issue Is Very Common And Is Specifically Caused By Normal Use Of The Vehicle. See: Sticky: Service and other Nissan manuals.