A flashlight may be necessary to see two slots the headlight plate cover goes into to close up properly. There is a label for lock and unlock. Before replacing the assembly test the slide mechanism for smoothness of slide. Turn the key to the on position. After plugging the bulb into the socket, slide it back into the chamber so the white pegs pass back through the holes. It can only go one way and there is a clip on the bulb that will help you determine which way it goes.
Today of course the driver side bulb blew. Push the casing back in and lock the casing in with the lever. They are turned different depending on sides but there is a small sticker to show which way to turn it. Then next to the lever you can see small rectanglearea with little xxxx kind of. You can do this completely by hand and not have to lift a wrench or screwdriver. You can also shop with us online and receive home shipping, or select Same Day Store Pickup when you need your parts in a hurry.
Push themetal clips away from the middle of the cover. These bulbs have a very high voltage that runs through them, even if the battery is disconnected. If you must, wear gloves. The O-rings slide off and on like tight rubber bands. It's attached by 2 Phillips screws. Look behindthe headlight assembly, and you will notice a small section coverto the area directly related to the headlight.
Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. We had to change the low beam lamp the one on the top of the assembly , so once the clip was removed the lamp can be pulled out of the assembly. The lamps are in a plug-in fixture. Yes you can access the inner fender from the engine compartment. My step dad and I successfully replaced a headlight yesterday! Try to reset the light as close to the actual service time as possible, because you don't want to risk any problems or confusion.
If you want to chan … ge the one behind the battery, you'll have to remove the battery first so you can access it. To get the tab into the correct position to release, I used a set of adjustable pliers to force the tab down near the cover. I would add to the above the following: 1. Locate the seam between the nosepiece and the front fender either side. If you are replacing it install a new bulb. With the old bulb you can just pull it out without a care in the world, besides not damaging the assembly. Push in trip odometer button.
Next reach in with fingers and twist the white colored housing counter-clockwise until it snaps out. You have to press down on the locking tab, while trying to slide the release toward the fender. It took several probably 30-40 attempts before I could get the slide to move far enough to release headlight mechanism. You may want to remember that when changing out the bulbs on your car. Yes you can get the drivers die headlamp out without touching the battery. Move the wire snap on the headlight plate cover to release the headlight plate cover.
Oncethe cover is removed, look inside the assembly from the enginestandpoint. There is a small tab on … the top of it that you must depress to remove it. Answer Open the hood and look for the black 'sleeve' that holds the headlight. I practiced on the passengers side first as it is more easily reached. Put the socket back in its chamber. I've lost it trying to replace the bulb.
The headlight is now separated from the car. Mine would hardly move, too much crap in the slide area. Don�t remove all of it from behind the headlight itself, as it is there to keep excess amounts of water from getting behind the headlight. When headlight is back in place, slide the arm back into place and you are done. Let go of the trip button and push the minute button.
Sometimes you have to remove the light assy. Open Hood and pull the release lever at the back of the housing. . OnceI did that I was able to properly seat the bulb note: Aligning thethree little grooves is very important. Mine would move about half the distance necessary to release the headlight.