The fan noise comes from two fans located inside the high voltage battery. In order to properly diagnose and service your vehicle, Ford Motor Company, Ford of Canada, and service and repair facilities may access or share among them vehicle diagnostic information received through a direct connection to your vehicle when diagnosing or servicing your vehicle. Remove the two screws from the lamp assembly. Check the coolant and coolant level. Automatic locking mode When to use the automatic locking mode In this mode, the shoulder belt is automatically pre-locked. Ensure that the battery in your portable music player is new or fully charged and that the device is turned off. Insert the dipstick fully, then remove it again.
To complete installation, follow the removal procedure in reverse order. Locks and Security 104 Page 105 3. Note: If the vehicle is equipped with autolamps it will have the headlamps on with windshield wipers feature. Turns off when the speed control system is disengaged. Ford strongly recommends that you use extreme caution when using any device or feature that may take your focus off the road. Your personal code is now erased and only the factory set 5—digit code will work. The jack is only meant for changing the tire.
The indicator lamp is located in the center stack of the instrument panel just above the air vents. Most geographic areas zones have a magnetic north compass point that varies slightly from the northerly direction on maps. Your primary responsibility is the safe operation of your vehicle. If a warranty concern has not been resolved using the three-step. Failure to follow the specific warnings and instructions could result in personal injury.
The design and development of the side airbag system included recommended testing procedures that were developed by a group of automotive safety experts known as the Side Airbag Technical Working Group. Move the steering wheel up or down until you find the desired location. Accessory— allows the electrical accessories such as the radio to operate while the vehicle is not running. This program is separate from the New Vehicle Limited Warranty. Press to raise or lower the front portion of the seat cushion. Release the buttons and pull down on the height adjuster to make sure it is locked in place.
In track mode, the system will display and play the structure as if it were only one level deep all. Adjust the volume to a comfortable listening level. Press the left side to restore the window controls. Fog lamp control if equipped The headlamp control also operates the fog lamps. Accessory delay: Your vehicle is equipped with accessory delay. Seating and Safety Restraints 124 Page 125 5. If either of the lamps are not operating, stop using the camera, at least in the dark, until the lamp s are replaced and functioning.
Make sure that the headlamp control is in the off position. If a low battery condition is detected or the ignition is turned off or to the accessory position, the rear window defroster will not function. If you are checking tire pressure when the tire is hot, i. Stop the vehicle as soon as safely possible, turn off the engine and let it cool. Fixed code uses the same coded signal every time. Loaded vehicles, with higher centers of gravity, may handle differently than unloaded vehicles. The fact that the pretensioners or airbags did not activate for both front seat occupants in a collision does not mean that something is wrong with the system.
Press R to turn the rear window defroster on. Turn the handle counterclockwise and lower the spare tire until it can be slid rearward and the cable is slack. The heated seats will activate when the ignition is in the on position. Drive in a moderate fashion avoid heavy acceleration and deceleration and have your vehicle serviced immediately by your authorized dealer. Locks and Security 113 Page 114 4. This allows you to use the full message center functionality by clearing the message.
Drive in a moderate fashion avoid heavy acceleration and deceleration and have your vehicle serviced immediately by your authorized dealer. Install the new bulb in reverse order. If the procedure needs to be repeated, you must wait 30 seconds. Shield your eyes when working near the battery to protect against possible splashing of acid solution. An oil change is required whenever indicated by the message center and according to the recommended maintenance schedule. The hazard flashers will operate when the ignition is in any position or if the key is not in the ignition. See Active park assist in the Driving chapter for more information.