If any closure is not closed, the park lamps will not flash. Mobile Communication Equipment includes, but is not limited to, cellular phones, pagers, portable email devices, text messaging devices and portable two-way radios. It will take you longer to stop the vehicle. Works on any computer, laptop, smartphone, iPad, iPhone, or tablet. Be sure to ask your Ford or Lincoln Mercury dealership service advisor or technician about the multi-point vehicle inspection. Check to ensure the gasket is fully centered. Note: With the ignition and audio system off, you may press the volume control to momentarily view the clock.
If the safety seat is not anchored properly, the risk of a child being injured in a crash greatly increases. Check your tire pressure to ensure tires are properly inflated; refer to Inflating your tires in this chapter. Memory presets: To set a station: Select frequency band, tune to a station, press and hold a preset button until sound returns. Note: In the illustration, the vehicle on the bottom is used to designate the assisting boosting battery. This manual cover specifications, diagnosis and testing, in vehicle repairs, component removal and installation.
Compass calibration adjustment Perform compass calibration in an open area free from steel structures and high voltage lines. It will be illuminated solidly if there is a fault with the system and traction control will be disabled. Memory presets: To set a station: Select frequency band, tune to a station, press and hold a preset button until sound returns. Detailed Satellite instructions are included with the dealer installed kit. Flash-to-pass Pull toward you slightly to activate and release to deactivate. Turn the headlamp switch to the autolamp position. Remember to turn the ignition off when refueling to allow this feature to correctly detect the added fuel.
Correct vehicle usage and the authorized disposal of waste, cleaning and lubrication materials are significant steps towards this aim. Drive the vehicle 15 ft 4. Fixed code uses the same coded signal every time. If you do not want to disclose this information, do not activate the 911 Assist feature. The factory manual delivered by us it contain the repair manual, parts manual and the owner manual in a single file. The following table tells you which transmission each code represents. Dolby: Works in tape mode to reduces tape noise and hiss.
Have your tow truck operator refer to this manual for proper hook-up and towing procedures for your vehicle. Tape eject: Press to eject the tape. This indicates a problem with the electrical system or a related component. Traction Control if equipped : Flashes when the traction control system is active. Each arm has 2 mounting positions to the chassis and one ball joint attachment at the wheel knuckle. Locate the vertical adjuster on each headlamp. If the warning stays on or continues to come on, contact your authorized dealer as soon as possible.
For further information, refer to Rear Console Audio Controls if equipped later in this chapter. Drive in a moderate fashion avoid heavy acceleration and deceleration and contact your authorized dealer as soon as possible. During full daylight, the instrument panel will still be visible with the headlamps operating. Turn ignition to the on position. When activated, the compression icon will illuminate in the display. Normally, the service engine soon light will stay on until the engine is cranked, then turn itself off if no malfunctions are present. Rear defroster control: Removes ice and fog from the rear window.
Furthermore, due to printing cycles it may describe options before they are generally available. The set point temperatures in Celsius will be displayed in half-degree increments. To unfasten, press the release button and remove the tongue from the buckle. PowertrainCare — Covers 29 critical components. Ford strongly recommends that you use extreme caution when using any device or feature that may take your focus off the road.
Autolamp control The autolamp system provides light sensitive automatic on-off control of the exterior lights normally controlled by the headlamp control. Remove the bolts, then pull the headlamp assembly forward and disconnect the electrical connector. A significant decrease in braking performance may occur. Your primary responsibility is the safe operation of your vehicle. The preselected time lapse is adjustable up to approximately three minutes. The top of the high intensity area should touch the horizontal reference line, if not, the beam will need to be adjusted.