Release the black trip meter reset stick. Here the general procedure to reset service light. If it is in the owners man, I would invite someone to kindly tell me what page it is on. Turn the ignition off and then start the engine to verify the indicator has been reset. After the above operation, the master warning light comes on, a warning tone sounds and the message appears to inform you that the engine oil maintenance data has been reset. Problem is, I do not see either on my display.
Release the reset button at the interval you desire. At the same time it is true, the only American still in place, the Chrysler Voyager duo and Dodge Caravan Plymouth having disappeared , collapsed from 370,000 to 175,000. You must re-perform the procedure You seem a little skeptical. Get in van and close the door. Odometer reading should appear and light will be out. They might have kept it out so you'd have to drive to the stealership and they could scam you into services you don't need. That will reset the light for another 5,000 miles.
Your tires are an important aspect of driving safety and when your tires do not have the proper air pressure, it can lead to more serious issues down the road. Thank you so much for visiting! When it stops flashing, turn the key off and release the button. The main steps to remember are that you must put the display or odometer to the main counter, and neither of the trip or short term odometer settings. Continue to hold the button and watch the odometer. The maintenance light is supposed to come on at 4500 mile intervals and blinks then turns off every time you turn on the truck for the next 500 miles and at 5000 miles it will stay on meaning that is when the oil change is due and so on for every 4500-5000 miles from the times it is reset.
Using the Multi-Info Display When doing the oil change and topping up fluids you will need to use the following specifications: Engine Size 2. I just want to reset my maintenance required light. I need to reset that annoying little maintenance light. This third Sienna is based on the platform of its predecessor, but benefits from technical developments. Using the multi-information display if equipped : Multi Info Display 1.
This is the small rectangular box located in the center of your Sienna instrument cluster. You will have to go to Auto Zone to have the code read and then fix the code problem and then clear code with code reader Regards, Lee Davidian Thank you for using FixYa. This will tell you the system has been reset. This light will come on when after about 4500 miles since last oil change and a reset. This is explained in the owners manual on page 136. To establish your Personalized Oil Reset Percentage perform the following procedure: 1.
Hold down the knob for at least 5 seconds. The reset can be performed by following these instructions: 1. I thought the act of changing the oil was enough to reset the warning, but not so. This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change. The odometer indicates '000000' and the light goes off. Hold the button down until the indicator light blinks three times, then wait several minutes to get an accurate reading of tire pressure and turn the vehicle off.
Go to step 3 Vehicles with smart key system 1. If you mean the oil change maintenence light. It will continue to do so until it is reset. Before starting, make sure that the odometer is not on one of the trip mileage odometers but is displaying the standard odometer. It will stay on for a few seconds after you start the engine until you reach 5000 miles, in which it will stay on constantly until reset.
After a little research, I figured out why it flashed and how to reset it. If you check your tires and the tire pressure is correct, it may be necessary to reset the system. Turn the ignition to run one position before starting engine. Ensure Trip Metre A reading is shown. The light should be reset after every oil change as the computer keeps track of the miles to warn you when it's time again should you forget. On my Tundra, I push odo trip until I reach the Trip A screen.