It gives good standard deviation in velocity and in the 41-43 gr loads in my guns has been very accurate. Velocity was around 2,950 fps. I don't get enough range time with it either to really get a chance to test out a lot of loads and or bullets either. I have tried H4831 but no luck. Have you tried any seating depths tests? This would help with the vibrations in the barrel.
I called Sierra tech support to get specs but they said they didn't have any info available. When I quit shooting that rifle, it had 1,400 rounds and still shot good. I have several groups of rounds loaded up in a grain gradient from 38. Anyone know anything about this new bullet from Sierra? Different pressures and velocities will 'whip' the barrel in different frequencies. Your load seems a lil bit mild with the 40. Until I shoot out this barrel, I don't mind sticking with them when they perform this well on a 5 shot group.
When I shot long and short range benchrest, I used a wad of toilet paper over fast powder to fire form. It just plain didnt work. The 90 berger went poof every other shot though. If I am going to be burning a lot of powder and chasing accuracy , and I have separate lots, I usually combine them all and work up to my load so I have a large amount of consistent powder and don't need to be tweaking all the time i open a new container. I'm not at all concerned about this.
I loaded them out to 2. Sounds realistic to me considering some minor variances that could cause a change in pressure. For more great information on reloading please checkout thereloadersnetwork. Have you let someone else shoot the rifle? For a stability factor on a cool day at sea level you'll need about 1:6. You know, the whole load density issue. Each bullet is a hollow point and is designed with a very small meplat in order to achieve the highest ballistic coefficient possible.
I think that anyone that says the 22-250ai dont feed well, has never had one before. Another thing I think it also tests is the harmonics of the barrel. Good luck and please let me know what works for you. However, H4831 has worked great with the 100 gr Sierra bullets for the same rifle. Although, the info I read was more concerned with pressure. The products offered for sale on this page can expose you to chemicals, including Lead, which are known to the State of California to cause cancer, birth defects or other reproductive harm. All with same brass, primers, dimensions, etc.
It seems to be about the same test. I think I'll let others speculate how long that barrel would last. I've had great success with flat base bullets. The rifle is an old ruger with a shortish barrel. We will be happy to answer any of your questions and ensure that you have the right supplies and equipment for a day at the range or in the field. I've shot thin jacketed 40gr varmint bullets out of 7 twists at much higher speeds with no issue so I just don't see how it would be an issue with this bullet which should probably be fine in a 7 twist at higher velocities. Here are a few links that explain some of the steps I went through when developing a load for the rifle and the results.
The elongated ogive and bullet point meplat reducing increase the ballistic coefficient over other manufacturers. The clean cold bore shot makes this. For more information, go to. If you handload for 22-250, 223 Remington, 6. Must use coupon code at checkout. If it is much less than 2,000 rounds then it would not be worth doing for me. And ya can't forget about bedding.
The 6mm 95-grain MatchKing will be available in boxes of 100 and 500 bullets. This is not loaded ammunition. The best results are generally obtained when one uses the longest range that they can. By no means my typical results at 960 yds, but I think it illustrates that the load is more capable than the shooter i. I like to use slower powders whenever possible because of 243 Win being an overbore cartridge. Never did much target shooting with it for a good comparison though. Funny thing was that, when I looked at the Nosler 95 Bal Tip, it had almost the same exact loading for 4831.
Sierra Bullets is excited to release load data for four of our newest bullets: the , , , and. I think what I'm trying to get at is, how far past 40. Does anyone have the newest version of Sierra's data and help me out a little?. Actually, I have a 100gr Sierra Pro Hunter load that is the most accurate load for my 243s. This bullet is a popular choice for across the course and long range target customers. Who cares if a bullet is boring. It does not seem to vary much.
Finally, he had to buy a gun safe. I guess I'll be keeping an eye on what you're doing. It would possibly stabilize the Amax, but I already have 200 Matchkings laying around. Cannot remember the exact velocity as I have not worked with it for a while and do not have my data handy. Are you trying to say that the 308 Winchester load data has been updated, and that information downloaded before Feb 6 should be discarded? According to Sierra, the ballistic coefficient of the new bullet is.