. At this point, I'll go over how to change the filter. Torque them to 97 in-lbs. However, very little fluid will drip. I had a noticeable improvement in shift smoothness when I used the full syn at my scheduled drain interval. It's been 30,000 to 90,000 miles and 3 to 5 years. Lower the vehicle back to the ground.
We are able to pass on wholesale prices to you based on our high volume buying power. The engine in your 1999 Chevrolet S10 should be running when you perform a transmission fluid level check, otherwise it will be inaccurate. Connected access services are subject to change. Save all fluid removed so it can be accurately measured, because you should replace exactly the quantity you removed. With a flashlight, check the transmission underneath the vehicle for leaks.
Slide the jack under the vehicle to raise it off the jack stands. I took the Tahoe in a few months ago for this service but they talked me into a flush. Especially if it was dirty. It cannot be flushed clean. Requires the Android Auto app on Google Play and an Android compatible smartphone running Android 5. However, on your truck, the filter media is made of a paper product very similar to the media in an engine oil filter. Cargo and load capacity limited by weight and distribution.
Follow us on - - This site is not owned or operated by General Motors Company. For more information, visit www. I guess I could add to what Atomic posted. Cargo and load capacity limited by weight and distribution. Remove the filter and the seal, that will require a small prybar to pop seal out of the bottom of the housing. Cargo and load capacity limited by weight and distribution.
Install the new seal, filter and replace the pan when it is completely done draining. You do not need to get all of the fluid. Always check rear seat before exiting. The weight of passengers, cargo and options or accessories may reduce the amount you can tow. I also had to remove the neutral switch assembly in which I broke trying to unplug the wiring harness. We are not a transmission shop.
If you do not have one, then I suggest you get one. Close to 60% or more automatic transmissions will fail within the approximate 125,000 to 185,000-mile range. See participating dealer for other restrictions and complete details. Next, replace the rear Torx screw on the shift linkage bracket and tighten the front one. I did drop the pan and change the filter and seal. It is completely safe and easy to do. I'm going to skip the filter swap this time 43k and go ahead and swap it at 75k.
Can't remember the name though but it helps shudder and has an additive for seals and trans parts. Cargo and load capacity limited by weight and distribution. After refill check oil level. Most folks use a hook tool to get it out. If you are not comfortable in doing it yourself, find a good Tech that understands the importance of changing the filter and have him do the job.
The box I have is 41-110. Careful not to scar any of the surfaces while you do this. Now I planned on changing the filter. We install shift correction kits to valve bodies and hard parts are used in critical areas to improve durability. Next, attach one end of your clear tubing and use the hose clamp to secure it and to ensure no leaks. This site is intended for reference only.
So to help with the fluid in the tranny pan, you can go ahead and pump out the fluid down there. The weight of passengers, cargo and options or accessories may reduce the amount you can tow. I chose to replace it. Message and data rates may apply. When adding transmission fluid to your S10, be sure to add it slowly as the transmission fluid capacity is reached quickly and it is difficult to remove excess fluid if you overfill.
Ship to entire United States excluding Alaska, Hawaii, and Puerto Rico. This video shows you how to add transmission fluid to your 1999 Chevrolet S10. Does not include emergency or security services. What you are supposed to do is go to a lube place and have them hook the trans cooling lines up to a machine that filters, and cleans the flui … d. Fluid capacity depends on the transmission on your vehicle, it should be stamped on the transmission pan. If you trap fluid with the gasket, you will have a leak that can only be fixed by dropping the pan again.