If the position changes, replace the auto-tensioner. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Install the starter cable A and harness clamp B. Warm up the engine to normal operating 8. With a hammer and special tools, install a new Rotor Slip Ring Test front bearing in the drive end housing. Remove the cylinder head covers see page 6-34.
Remove the front upper cover A , rear upper cover under the oil pan. Hg 07746-0010300 Attachment, 42 x 47 mm 07749-0010000 Driver. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Disassemble the starter as shown at the beginning of this procedure. If you find a term or abbreviation in a 2001 or later manual that is unfamiliar to you, check this list. Release the vacuum, then apply vacuum again. Remove the timing belt see page 6-20.
Tighten it by hand, do not use a wrench. Use the Maintenance Schedule for Severe Conditions if the vehicle meets any of the qualifiers in the Severe Conditions schedule or if the vehicle is normally driven in Canada. Remove the rocker arm assembly see page 6-38. Remove the bolts A securing the shift cable holder B , then remove the shift cable cover C. P0500 Honda Description The vehicle speed sensor outputs a 4 pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. Clean the camshaft bearing surfaces in the cylinder ramps. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term.
Original parts have self-adhesive labels. Support the stator housing in a vise, and drive out Rectifier Test the front bearing with a brass drift A and hammer. Disconnect the engine wire harness connectors on the left side of the engine compartment. Align the pointer A on the front upper cover with the No. When worn or area damaged At 2nd gear 39.
Manufacturer, Make, and Type of Vehicle b. Use the Maintenance Schedule for Severe Conditions if the vehicle meets any of the qualifiers in the Severe Conditions schedule or if the vehicle is normally driven in Canada. Remove the intake manifold see page 9-4. If the auto-tensioner has extended and the timing 8. Install the valve spring and valve retainer. Is the voltage less than 13. Track Front 1,680 mm 66.
Remove the holder pin for 2000-2004 models from the auto-tensioner. Turn the crankshaft so its white mark A lines up 3. Wipe the camshaft clean, then inspect the lift 10. Inspect the ignition timing see page 4-16. If a term is not listed below, it did not change. Manufacturer, Make, and Type of Vehicle b.
Install the back cover A , then install the camshaft Install the cylinder heads in the reverse order of pulley B. Ignition timing At idle check. When worn or area damaged At 2nd gear 33. Check that there is no continuity between the service limit, replace the brush holder assembly. Raise the engine speed above 1,000 rpm.
Insert the feeler gauge A between the adjusting screw B and the end of the valve stem and slide it 2. Remove the four insulators A , rear housing B rectifier B and rubber seal C. Remove the valves see page 6-46. Make sure each ring the control shaft. Remove the idler pulley bolt A and idler pulley B , the timing belt adjuster in its current position. Remove the timing belt see page 6-20. Manufacturer, Make, and Type of Vehicle J35A1: 3.