Use the wrench supplied in the tool kit to remove the spark plug. Each system is enginee red for the particular application. Drain the carburetor into a suitable container. Install the spark plug in the plug cap. It is intended for racing vehicles and may not oper ate smoothly at idle or part-throttle. Shut off the engine before performing engine must be run, make sure the area is well ventilated.
Reinstall the air cleaner element and the cover. Remove the spark plug cover and cap. Turn the relay switch on. Make sure the Oil Alert switch is on. Slowly pull the starter grip until resistance is felt. Customer Relations Depxtmern 1500 Morrison Parkway Alpharetta. If you are not willing to field questions then your post will be removed.
Clean any dirt from around the spark plug base, then remove the spark plug. Pull the starter grip until compression is felt, then pull briskly. Exhaust gas contains poisonous carbon monoxide. However, to avoid the inconv. Turn the fuel valve on.
Loosen the bolts and nuts and remove the muffler. Start the engine and make sure the pilot filament may be burnt out. There is no need to modify your factory wiring harness and in most cases your car may be retur ned to stock in a matter of minutes. Always keep the kit with the generator. Make sure the oil alert switch is on.
Operate the generator on a level surface. Avoid excessive stress or pulling on the wires, as this may damage th e wiring harness. The generator may be hard to start if a load is connected. If the Oil Alert Switch is tripped, add oil to the top of the oil filler neck, re- set the Oil Alert Switch, P. If not, the oil alert switch will turn off after starting.
If you are the manufacturer or developer of a commercial product, please message the mods before posting, but we will usually allow new product promotion as long as you stay to answer questions. Visually inspect the spark plug. Please note that the injector response time will be different with and without the factory injector resistor pack. Check the engine oil level. This product is legal in California fo r racing vehicles only and should never be used on public highways.
Use any brand of regular grade automotive preferred with an antiknock Cost of Living Council formula higher. Is still available for reassignment by the end user. These drivers may be used with peak and hold or saturated type injectors. Wash the element in a non-flammable or high flash point solvent and dry it thoroughly. Soak the element in clean engine oil and squeeze out the excess oil. If the generator is tilted, fuel spillage may result. If any fuel is spilled, make sure the area is dry before testing the spark plug or starting ignite.
Consult the factory service manual for more information. Measure the plug gap with a feeler gauge. If any of these are lacking, we suggest checking simple things first. We have a zero tolerance policy for that sort of thing and it is strictly enforced. Note that wire polarity is not important for t he Air Temperature sensor. Storing the engine in this position will help to protect it from internal corrosion.
Do not damage the rubber gasket. Be sure the oil alert switch is on. Is gasoline reaching the carburetor? To prevent battery, connect charging cables first to the battery, then to the generator, and disconnect cables first at the generator. After installing sure the area is dry before starting the engine,. Turn the ignition switch key off or remove it from the generator.
Be sure to provide adequate ventilation. When the engine starts but stops immediately: Is there enough oil in the crankcase? Before storing the unit for an extended period: 1. Changing oil Drain the oil while the engine is still warm to assure rapid and complete draining. If the engine has not started by then, check through the starting procedure above to be sure that all switches, valves, etc are in the correct position. Depress the starter button until the engine starts.