On all two-piece flat wheel nuts, apply one drop of motor oil between the flat washer and the nut. Press to raise or lower the front portion of the seat cushion. Note: Do not start your engine with the air cleaner removed and do not remove it while the engine is running. Ford recommends the use of a child safety seat having a top tether strap. Visually inspect the tires to make sure there are no nails or other objects embedded that could poke a hole in the tire and cause an air leak. Set the parking brake on both vehicles and stay clear of the engine cooling fan and other moving parts. Remove the panel cover to access the fuses.
Position the jack to raise the front or rear wheel. Box 1580, Station B, Mississauga, Ontario L4Y 4G3. Put the indicator back in and ensure it is fully seated. Only demand interior lamps will stay on for the entire 30 minute period. Note: Do not start your engine with the air cleaner removed and do not remove it while the engine is running.
They change them from time to time to keep it interesting and if you happen to own one of the sample vehicles, then you just scored free unlimited access until they change it again. To install the new bulb, follow the removal procedure in reverse order. Lift the hood and secure it with the prop rod. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. Failure to drive cautiously could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time.
Department of Transportation-Tire quality grades: The U. See your Ford or Lincoln Mercury dealer. Route the child safety seat tether strap over the back of the front right-hand passenger seat as shown. Place the gearshift in P Park. Dealer installed satellite kit only available in the continental United States. See Attaching safety seats with tether straps in this chapter. Note: If your tires show uneven wear ask a qualified technician at a Ford or Lincoln Mercury dealership to check for and correct any wheel misalignment, tire imbalance or mechanical problem involved before tire rotation.
So the best I can do is put it all on the table and make sure you have all the information to make an informed decision. Go to the front of the vehicle and release the auxiliary latch that is located in the center top of the grill. Poor wiper quality can sometimes be improved by cleaning the wiper blades, refer to Windows and wiper blades in the Cleaning chapter. S and Canada should contact 1—800—444—3311. While the engine idles, turn the steering wheel left and right several times. When towing, trailer tongue load or king pin weight is also part of cargo weight.
Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a collision be replaced. You are strongly urged to buy a reliable tire pressure gauge, as automatic service station gauges may be inaccurate. Have a qualified technician at a Ford or Lincoln Mercury dealer check the wheel alignment periodically. If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount. To remove a fuse use the fuse puller tool provided on the fuse panel cover.
Note: When you turn off the speed control or the ignition, your speed control set speed memory is erased. Flash to pass Pull toward you slightly to activate and release to deactivate. Copyright © 2004 Ford Motor Company. Let us know what you think using the contact link to leave some feedback or ask a question. Tie down the load so that it does not shift and change the weight on the hitch.
If the air bag is not replaced, the unrepaired area will increase the risk of injury in a collision. If the fluid level is low, start the engine. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. Park the booster vehicle close to the hood of the disabled vehicle making sure the two vehicles do not touch. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. Check that the tire lies flat against the frame and is properly tightened.