Remove pilot tube and wiring from gas valve, Mark all wiring for reassembly. Switch, conveyor reversing Check continuity between switch terminals. Reassemble in reverse order and check system operation. Reassemble in reverse order and check system operation. Remove rear control box cover. Remove all wires and mark for reassembly. Remove screws from the bulkhead plate on inlet gas pipe and remove inlet gas pipe.
If these readings are not achieved, replaceconveyor motor. Remove mounting screws from control and remove burner control. Remove rear control box cover. If voltage is present, be sure that relay contacts stay closes during the 20 minute cool down. Shut off power at main breaker. Shut off power at main breaker. Shut off power at main breaker.
Turn adjusting screw on air pressure switch clockwise until heat shuts off. Shut off power at main breaker. We are committed to offering our customers a one stop-shop for all their parts and repair manuals. Remove rear control box cover. Remove front control box cover. The ignition controlrequires a minimum of 0. Remove connecting links from conveyor belt.
Remove conveyor belt from conveyor. Disconnect all wiring from motor and mark for reassembly. Reassemble in reverse order and check system operation. Shut off gas supply to the oven and disconnect the flexible gas line to oven. Measure frequency across theyellow and white wires at the motor connector.
Remove four mounting screws from fan frame. Discharge capacitor before removing wires. Conveyor motor If there is voltage supplied to the hall effect sensor, check for a frequency output from the hall effect sensor. If there is a read-out on the control, set the control to maximum temperature see installation operations manual for temperature adjustment. Heating element may now be unbolted and removed. Reassemble in reverse order and check system operation.
Remove all wiring connections and mark for reassembly. Choose from Lincoln models including 1116000A 1116-000-A, 1117000A 1117-000-A, 1130000A 1130-000-A, 1131000A 1131-000-A, 1132000A 1132-000-A, 1133000A 1133-000-A, 1300, 1301, 13014 1301-4, 1302, 13024 1302-4, 1303, 1304, 13044 1304-4, 1305, 13054 1305-4, 1306, 1307, 1308, 13084 1308-4 and many more. To reset the ignition control,turn off the power switch for 45 seconds, then turnthe switch on to re-try ignition. Shut off power at main breaker. Shut off power at main breaker. Reassemble in reverse order and check system operation.
Check new heating element for proper voltage. Be sure to calibrate new air pressure switch. Remove rear control box cover. For getting required parts you can get it from www. Disconnect bypass tube from gas valve.
You can read our Cookie Policy , which describes browsing and search options available to you. Reassemble in reverse order and check system operation. Depress spring clips on sides of switch and push out. For proper calibration, see below. Shut off power at main breaker. Checkpower plug to be sure it is firmly in receptacle.