Remove the 12 x 1. Have the system inspected by your Honda dealer as soon as possible. All other features remain auto- matically controlled. Hold the auto-tensioner A with the maintenance 9. Honda's recommendations on where to place rear-facing and forward- Small children: Not recommended, facing child seats in your vehicle. Check the piston for distortion or cracks.
Check the wheel alignment see page 18-5. Apply vacuum to the hose. Remove the front mount bracket support nut. Install the fuel tank vapor control valve in the reverse order of removal. Connect C103 knock sensor connector terminal Malfunction No.
However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Attach the fuel pressure gauge. Check the cap malfunction indicator lamp on, you can and tighten it until it clicks several damage your vehicle's emissions. Let the engine idle for 2 minutes. Install the back cover A , then install the camshaft Install the cylinder heads in the reverse order of pulley B. Install the throttle cable, then adjust it see page 11- 242.
Test-drive the vehicle on a flat road in the D4 10. Remove the throttle cable A and cruise control 6. Make sure both the front and the back of the seat are securely latched before driving. At the wire harness side, check for continuity 14. Apply new engine oil to the piston pin snap rings A and turn them in the ring grooves until the end gaps are lined up with the cutouts in the piston pin bores B. Install the reserve tank cap.
To prevent damage to the control lever joint, be Reinstall the drain plug using a new washer for sure to remove the bolts securing the shift cable 1999-2001 models see page 14-137 or 2002-2004. If the engine is cold, the 1. Pry back each brush spring with a screwdriver, then Overrunning Clutch Inspection position the brush about halfway out of its holder, and release the spring to hold it there. Wipe the dipstick with a clean 3. Have the vehicle checked by your Honda dealer. After the belt has retracted, tug on it. The individual map lights, cargo area light, and the vanity mirror lights 5.
You can also obtain Co. If you are not sure how to clean and grease 2. The interior fuse boxes are located To open the fuse box on the underneath the dashboard on each passenger's side, pull the right edge. If the housing-to-outer rotor radial clearance 1. Place a shop towel under the fuel pressure regulator, then relieve the fuel pressure see page 11-215. Tighten the front mount bracket support nut.
Apply vacuum to the hose. Measure the voltage between the D14 and B20 or B22 terminals. Clean and install the bearings on the No. Vehicles Treadwear Traction The tires on your vehicle meet all U. Severe Conditions: Driving less than 5 miles 8 km per trip or, in freezing temperatures, driving less than 10 miles 16 km per trip. Shift to any position other than 1. Any Operation is subject to the following two other transmitters you have will also conditions: 1 this device may not cause need to be reprogrammed.
Procedimiento de detalle para encontrar códigos de problemas probable diagnóstico se acoge. Disconnect the mainshaft speed sensor connector 10. Remove the idler pulley bolt A and idler pulley B , the timing belt adjuster in its current position. When worn or area damaged At 2nd gear. Does the misf ire occur in the cylinder where the ignition coil was exchanged? However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. If you can pull the belt out, it is not locked and you will need to repeat these steps. Apply new engine oil to the bolt threads.