The radio will remain tuned to the new station until you make another selection. Many factors, such as vehicle loading, road condi- tions, and driving conditions, influence the chance that wheel lift or rollover may occur. It could slip off the jack and hurt someone near it. Do not drive the vehicle with the seat in this posi- tion, as it is only intended for entering and exiting the third row seats. Adjust the tire pressure as required. The recirculation symbol will illuminate in the display when this button is selected. It is a true crossover-it will not replace a minivan for utility and people carrying, but it is more and more usable than a sedan or hatch.
Turn on the multimedia system. . To enable the window controls, press and release the window lockout button again setting it in the up position. The system will provide mechanical steering capability if power assist is lost. Clean with a wet soft rag.
In most situations, the vehicle will drive normally and will not require towing. Damage to the 110-115 Volt electrical cord could cause electrocution. This rating information can be found on most washer fluid containers. Raising the vehicle higher than necessary can make the vehicle less stable and cause an accident. This will provide more space when accessing the jacking tools and when operating the winch mechanism. As the cover nears the liftgate opening, guide the rear attach- ment posts on both ends of the cover into the notches in the trim panels. If the temperat ure reading does not return to normal, turn the engine off immediately.
The system automatically adjusts the air temperature, the airflow volume, amount of outside air recirculation and the airflow direction. The system automatically adjusts the temperature, mode and fan speed to provide comfort as quickly as possible. Release the lever once the seat is in the position desired. Remember to disconnect the cord before driving. Pull down then rearward towards the rear of the vehicle then down to engage the locking mechanism. Lift the control lever with the other hand, allow the seatback to move forward slightly, and then release the lever.
Use tires of the recommended load capacity for your vehicle. Be certain that the seat cushion is locked securely into position before using the seat. Pull the bar upward to move the seat forward or rearward. Chemicals that make roads passable in snow and ice and those that are sprayed on trees and road surfaces during other seasons are highly corrosive to the metal in your vehicle. Do not expose the disc to direct sunlight. Whenever the vehicle is started the system will be in this mode. It cannot prevent wheel lift due to other factors, such as road conditions, leaving the road- way, or striking objects or other vehicles.
To reset the oil change indicator system after performing the scheduled maintenance perform the following procedure: 1. Odometer Reading Date Repair Order Dealer Code Signature Authorized Chrysler Dealer 36,000 Miles 60,000 km or 36 Months Maintenance Service. This allows you to cool the compartment when the climate control is in the cooling or heating mode. An in-floor storage bin is located behind each front seat. Leaves collected in the air intake may reduce airflow, and if they enter the plenum, they could plug the water drains. Tire pressures will also increase as the vehicle is driven — this is normal and you should not adjust for this in creased pressure. Lower the lever to lower the seat.
An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Seat belts reduce the possibility of ejection and the risk of injury caused by striking the inside of the vehicle. The sudden movement of the seat could cause you to lose control. While driving, ease up on the accelerator. In addition, inspect the exhaust system each time the vehicle is raised for lubrication or oil change. Installation of this compact sparetire affects vehicle handling.
Remove the jack-handle components 1, 2 and 3 from storage and assemble them. The turn signal lights will flash to acknowledge the unlock signal. It is important that you distribute the load evenly over the front and rear axles. Preparations for Jump-Start The battery in your vehicle is located between the left front headlight assembly and the left front wheel splash shield. Vehicles equipped with an automatic transmission cannot be started this way. This will lock these components together. The gear position will display in the instrument cluster on the transmission range indicator.
Plastic is not as scratch resistant as glass and therefore different lens cleaning procedures must be followed. Failure to do so could result in loss of vehicle control. The Trailer Tow Package may include a four- and seven- pin wiring harness. The Journey service manual will show you which tools and size to use. If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol.