It is fully printable, print 1 page, 1 chapter or print the entire manual and put it in a 3-ring binder. This manual was prepared to help you under- stand the operation and maintenance of your vehicle so that you may enjoy many miles kilometers of driving pleasure. Run the fuel tank breather and drain hoses to the upper side of the cross bracket. If the roads are wet, lightly apply the brakes for a short distance before parking the vehicle to dry the brakes. To maximize vehicle performance, the fuel tank is located as low as possible to lower the vehicle center of gravity. Exhaust Pipe Manifold Holder Nuts 6. Do not use fluid from a container that has been left unsealed or that has been open for a long time.
Your name, address, and telephone number. The engine rotation fluctuations become larger than conventional vehicles. Prior to shipping from factory, all vehicles receive balance aligning for engine, transmis- sion, and clutch, as well as quench driving of brake pads and rotors. To avoid or reduce the risk, follow the information and instructions carefully. If the seal is torn or is leaking, replace the bearing. Inlet Camshaft Position Sensor 4. Front Wheel Rotation Sensor 2.
Differential oil temperature usually increases concurrently as the transmission oil temperature. Tetra Lever Shaft Drive System When the drive force is applied to the rear wheel, a reaction force is generated as shown in the diagram. If the clearance is between 0. Check for the heat deterioration of the brakes and parts around the brakes. Al- though no adjustments are required, a thorough visual in- spection must be made at the intervals specified by the Pe- riodic Maintenance Chart.
Be careful not to allow the brake cleaner to splatter on rubber parts, bumper, etc. Speed Sensor Output Signal 68. If the reading is incorrect, check the following. Pinion Gear Shim s 6. Ps: Standard Atmospheric Pressure abs.
If Mobil 1 0W-40 is not available, Mobil 1 10W-40 100% synthetic may be used; however, some performance loss may be noticed. If they are damaged, replace them. Always pull the chain taut while turn- ing the crankshaft. Such a shock to the pump can damage it. Torque - Shift Drum Cam Holder Bolt: 12 N·m 1. Clamp Hold the front wheel rotation sensor lead. Inlet Air Temperature Sensor 3.
Fuel Level Sensor Lead Connector 3. This frees the rider from handling the ignition key, a helpful feature in the rain or after putting on gloves. Road Clearance 125 mm 4. Left and Right Front Middle Fairings 10. Toothed Washer, 37 mm 1.
Battery 12 V 14 Ah 2. The use of additives, chemical materials or abrasive compounds is prohibited. From the exterior, revision prominently present on the form of her new bumpers, plus a new hood which reinforce already. The metallic brake pads and brake disc rotor may rust together when the brakes are not applied: — If the vehicle is not idled for 20 seconds without the brakes applied, or if the brakes are applied when the vehicle is shut off, the rotor and pads can rust together, even when the brake pads are dry. Headlight Fuse 10 A 17. Follow these important driving rules to help ensure a safe and comfortable trip for you and your passengers! The brake pad material helps maintain braking performance in a wide range of weather and driving conditions.
Main Fuse 30 A 7. Ignition Fuse 10 A 6. L: Apply a non-permanent locking agent. Rear Wheel Rotation Sensor 4. Water temperature sensor trouble Inspect see chapter 3.
Transmission shifting should return to normal when the transmission oil returns to normal operating temperatures. The vehicle may slowly move if the brake pedal is not depressed. Inlet air pressure sensor trouble Inspect see chapter 3. Make sure the area is well-ventilated and free from any source of flame or sparks;. Run the oxygen sensor leads, and close the clamp. Miscellaneous: Subthrottle sensor trouble Inspect see chapter 3. Run the fuse box 1 lead under the cross bracket.
Inspect the area surrounding the catalytic converter for heat deterioration. If the cap is opened when the vehicle is hot, it may cause fuel spray and there may be a hissing noise. Ring Gear Shim s 2. Check the engine, transmission, differential and under the vehicle for oil and coolant leaks. The fuel tank pressure is higher when the vehicle is hot, especially if the tank is more than half full. If the oil temperature exceeds 2848F 1408C while driving the color of the meter dis- played in red , change both the transmission oil and the differential oil after driving because these fluids have deteriorated because of the heat.