Apply new engine oil to all sliding and rotating parts. Sinking of valve seats Damage of manifold contact surface Camshaft oil clearances and end play 3. Engine page Bl-28 Engine stand mounting. Recharge it if neces- sary. It was manufactured with both manual and automatic transmission styles. Caution l If all the previous sealant cannot be removed from a bolt, replace the bolt.
See the changes in automobile engine manufacturing and why you should care. Apply sealant to the drive plate bolts and install them. Remove the drive plate lock bolts. Tightening torque: 19-25 N-m 1. Start the engine and check as follows: l Ignition timing. Cylinder head cover Installation Note.
Replace the valve guide if necessary. Locking of connector When locking connectors, make sure to listen for a click that will indicate they are securely locked. Install and adjust the stabilizer. If not within the specification, adjust the idle by turning the air adjusting screw. Tighten After 60 months or 96,000 km 60,000 miles , continue to follow the described maintenance at the recommended intervals.
Remove the pulley lock bolt and pulley boss. Tightening torque Front: 37-63 N-m 3. Install the timing belt so that there is no looseness at the tension side. Caution l Be sure both rocker arm shaft oil holes face downward. Before removing the connecting rod caps, measure the con- necting rod side clearance.
Schedule 1 Normal Driving Conditions Number of months or miles kilometers , whichever comes first Months 7. Apply sealant to the flywheel bolts and install them. Tightening torque: 19-25 N-m 1. Replace the cam- shaft if necessary. Disconnect the negative battery cable. Press out the piston pin.
. Learn about timing belts and recommended maintenance guidelines. Apply clean engine oil to the bolt threads and seat faces. Disassemble in the order shown in the figure. Loosen the rocker arm bolts in two or three steps in the or- der shown in the figure. If deteriorated, replace with specified type and amount of oil. These manuals are your number one source for repair and service information.
Wiring Harness Wiring color codes Two-color wires are indicated by a two-color code symbol. Ohmmeter The ohmmeter is used to measure the resistance between two points in a circuit and also to check for continuity and diagno- sis of short circuits. Start the engine and fully warm up. Noise when engine is started after set- tina aporox. Assemble the rocker arm and rocker shaft assembly as shown in the figure.
Set the deflection specified below accordingly. Pour engine oil into the oil reservoir in the rocker arm. Cylinder head cover and gasket 14. Tighten After 60 months or 60,000 miles 96,000 km , continue to follow the described maintenance at the recommended intervals. Measure the connecting rod side clearances. Cylinder head Removal I Installation Note.