Camber and Caster The camber and caster are non-adjustable. Install the bearings so the numbers are visible. The safety alert symbol, on your vehicle or in this manual, alerts you to the potential for personal injury. Invert shock and mount bearing cap flats lightly in vise. Start the engine and let it idle for one to two minutes. Use pin spanner tool to unscrew the bearing 1.
Inspect or replace the crankshaft oil seal anytime the clutch cover is removed for service. Install the castle nuts onto the upper and lower A--arms. If the rear wheels slide while using the foot brake, reduce brake pedal pressure to brake the wheels without skidding. Lubricate the axle housing through the grease Torque the brake disc nuts to 16- -19 ft. Failure to check or maintain proper operation of the throttle system can result in an accident if the throttle lever sticks during operation.
The part number is printed on the decal. Polaris measures chain length in number of pitches. Always fill the reservoir as needed whenever the cover is loosened or removed to ensure proper diaphragm operation. Follow bleeding procedure on Pages 9. Remove spring and bushings from shock eyes. Always release the start button as soon as the engine starts. A synthetic brush may melt if components are warm.
If the beginning voltage is 12. Compress springs only enough to allow split keeper installation and prevent loss of spring tension. Heating of screws is required for removal. Thanks in advance for your help. Registration is fast and you can even login with social network accounts to sync your profiles and content.
Inspect chain for excessive wear, missing o--rings, etc. Have an authorized Polaris dealer perform these services. Certain products, including insect repellants and chemicals, will damage plastic surfaces. Never pry the sealing strip off or add any other fluid to this battery. Seal Seals 2 Tapered Spacer Bearings 2 10. Warm up the engine by running the vehicle for five minutes, or until operating temperature is reached.
If you move or are traveling within the country where your vehicle was purchased, Warranty or Service Bulletin repairs may be requested from any authorized Polaris dealer who sells the same line as your vehicle. Replace any component that is found to be Inspect the inside of the cover for wear or scoring. Any help in getting the manual would be appreciated. Perform the services outlined in the maintenance chart. Remove the screws and washers 1 from the front left-hand and right-hand cab mounts. The compression damping is factory set at position 4.
Proceed at a steady rate of speed and throttle opening. To adjust, turn the clicker 3. Turn the adjusting ring to the left A to increase preload. Also be sure that colors match when wires are connected. Make sure caliper moves freely on guide Disc brake systems light weight, pins. Measure clutch lever freeplay between the perch and the lever A. Federal law requires that this spark arrestor be installed and functional when the vehicle is operated on public lands.
Refer 2871329 on battery bolts. Clamp the body cap of shock securely in vice, with shaft end up. Set the nitrogen tank pressure regulator to 200 - 19. Make sure you have a clean work area to Brake Lines disassemble brake components. Install split keepers with the gap even on both sides.