Press to raise or lower the rear portion of the seat cushion. If finger pressure will not remove the thumb screw, use the lug wrench to loosen the screw. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. Remove the jumper cable from the ground metal surface. Install the child safety seat in a seating position which is capable of providing a tether anchorage.
Remove the access cover from the rubber strip behind the left door. Take precautions to avoid its dangerous effects. Do not start your vehicle in a closed garage or in other enclosed areas. Remove bulb socket from lamp assembly by turning counterclockwise. Open the rear doors and remove the thumb screw and anti-theft bracket. Empty reserve is the small amount of fuel remaining in the fuel tank after the fuel gauge indicates empty.
Mute mode Press the control to mute the playing media. Follow the recommended maintenance schedule and owner maintenance checks found in your vehicle scheduled maintenance guide. Dolby noise reduction Dolby noise reduction operates in tape mode. When in this position rotate the control upward for fast intervals and downward for slow intervals. If necessary, refer to Identifying components in the engine compartment in this chapter for the location of the dipstick. Stow the tongue end of the detachable anchor.
Improper use of the power outlet can cause damage not covered by your warranty. Use only Ford recommended replacement fasteners. Radio station memory preset The radio is equipped with six station memory preset controls. This loss of effectiveness does not affect normal driving and should not be noticeable to the driver. The fuel gauge may vary slightly when the vehicle is in motion or on a grade. Scan function The scan function works in radio mode. Pull the seat latch handle, then pull the seat toward the right side of the vehicle to disengage four pins from the floor mount.
Use the tapered end of the lug nut wrench to unscrew wheel ornaments attached by retaining screws. Do not pile cargo higher than the seatbacks to reduce the risk of injuring people in a collision or sudden stop. This program is separate from the New Vehicle Limited Warranty. Seek medical attention if irritation persists. Booster seats position a child so that safety belts fit better. This will reduce fogging on your windshield. Refer to Lubricant specifications in this chapter.
Any time that the media is changed, new radio station, etc. Connect: Secondary positive cable remains energized after disconnection. Rear axle jacking points - All models except E-450 and E-550: Rear axle jacking points - E-450 and E-550:. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from for that seating position until. As such, they cannot be treated like normal light truck tires. The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire.
Note: Do not put washer fluid in the engine coolant reservoir. The bars of varying length are for intermittent wipers. Please take the time to get well acquainted with your vehicle by reading this handbook. Check seat covers and buckles before you place a child anywhere near them. If a bulb is removed for an extended period of time, contaminants may enter the lamp housings and affect performance. If a light fails to illuminate, have the vehicle serviced.
The F-250 has a 5. The remote entry system allows you to lock or unlock all vehicle doors without a key. Disconnect the primary battery positive cable. Park the booster vehicle close to the hood of the disabled vehicle making sure the two vehicles do not touch. Many lights will illuminate when you start your vehicle to make sure the bulb works. Driving with a 4—speed automatic transmission Understanding gearshift positions To put your vehicle in gear, start the engine, depress the brake pedal, then move gearshift lever out of P Park. Make sure the gearshift is in P Park.