If anything is missing, I will notify on the description or pictures. Drain the oil in a proper container and then put the drain plug back in the pan. If we don't have the replacement part, we will refund your money. Sounds like a load of crap to me. The same 2 wire clips are there to release the housing. Headlights grow dimmer by up to 20% over time and eventually burn out - for this reason, we recommend changing your headlights in pairs. If there is voltage there you have a problem with the new bulb.
It probably takes 5 quarts but check for sure in your manual or ask when you are at the automotive store. However, although the part has been ordered for over 10 days, there is no word as to when it will be available and we are about to take a four-day trip! If this happens next time, They're pretty inexpensive. This is a clean Tail Light Assembly with for Mercury Montego model year 2005 to 2007 Passengers side. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. I paid it to get my car back for the weekend.
The video above shows you to replace the headlight in your 2005 Mercury Montego. The vehicle was taken to mullinax Ford of mobile 7311 airport blvd, mobile, al 36608 and a relay jumper was performed on the lights; however, the failure continued. The pre-stripped ends allow for easy connection. Names of service manager, etc. It is possible that there are 2 low beam and 2 high beam relays total. I can make the high lights come on by holding the high light, turn signal lever toward me this too is dangerous because I am blinding oncoming drivers. Some Mercurys have high intensity discharge headlights, sometimes referred to as xenon lights.
If your Montego has many options like a sunroof, navigation, heated seats, etc, the more fuses it has. Later testing revealed the problem to be intermittent. Maybe I will throw them back out on ebay and make a few dollars. I looked at the female connector that the bulb goes into and on one of the conductors, the plastic was broken. The next morning, both the automatic and manual positions worked. At one point, the automatic dashboard switch position worked for both dim and high-beams, but the manual switch position did not work. Drivers side headlight is very dim on low beam and goes out when on high beam.
I was surprised that it is rated at 40 amps. How did the interceptors get repaired or were they not included in the recall? Put the oil in and put the filler cap back on. Ah, to hell with it. I guess I will have to wait till it gets here and take some measurements Ken I understand the buyer beware quite well. We are not the original owners, but that should not matter on such a serious issue! If no leaks then back the car off the ramps and shut the car off on a level surface.
They kept my car 5 days, never called me regarding status, I called them on the 5 th day and I was told my car was modified and they could not fix it. The cruise control would work, but there were times the vehicle would surge as if you were pressing down and up on the gas pedal. Gently replace in backwards order as you removed it. If you need to replace a blown fuse in your Montego, make sure you replace it with one that has the same amperage as the blown fuse. Does anyone know what's involved in the swap and where do the ballasts mount? I Ship to the Lower 48 States but you can email me for more shipping options. If you have seen those newer vehicles with the bright bluish headlights and want to install them on your car its a fairly simple installation and an awesome accessory to any vehicle here are the step by step instructions 1. When the problem first occurred, neither position would work.
The failure mileage was approximately 109,000. The date each part was made or the date it finally rolled off the assembly line? The car has been taken to the local Ford dealer. I bought a new bulb, but when I removed the old bulb I noticed that the socket was melted on one terminal. ¶ this intermittent problem is consistent with a large number of complaints and reports for the 2003-2005 model years, and the problem is the lighting control module. The headlights worked, but the tail lights did not unless the brakes were being applied. The passenger side low beam connector is not used and should be insulated. The passenger side was harder for me.
Luckily I had other cars in front and behind me and could still see the road because of their lights. Todd and others, After I posted my note, I went onto Ebay and found a left and right headlight assemly with ballasts and bulbs for sale out of a Montego. The contact stated that the interior lighting, headlights, tail lights, and tag lights all failed to work. You should be able to see or feel the same type caps, The low beam outside, High beam inside. Please tell me this is a plug and play fit. Find replacement parts and upgrades for your 2005 Mercury Montego.
Four Seasons is a leading automotive aftermarket supplier of air conditioning and cooling system parts. After turning off the engine and restarting the warning light was off and everything seemed fine. My previous car was a brand new Crown Vic -1990 and I had that for 17 years before getting the used 2007 Ford Five Hundred! And it would take 5 to 6 hours. One connector for each ballast, one for each side. . This is certainly a serious safty issue.