Open the tailgate to expose the lamp assembly and remove the two bolts from the tail lamp assembly. To activate the heated mirrors, press the rear defrost button located on the climate control panel. Additional Car2U system information can be found on-line at www. Remote start the vehicle using your remote start fob. Turn the engine off and wait 15 minutes for the oil to drain into the oil pan. Go to the front of the vehicle and release the auxiliary latch that is located on the front bumper under the grill.
Each seat cushion can be flipped up into a vertical storage position. Note: The seat will not travel to its final position if the key is not in the ignition and the easy entry feature is enabled. This will lock the steering wheel in position. All of Chilton's online content for the 2010 Ford F-150 is updated monthly, so you'll have the most recent information on hand for any Do-It-Yourself project. Pull the air tube off from the air cleaner housing.
Washer fluid placed in the cooling system may harm engine and cooling system components. Your vehicle is not equipped with the Ford Ambulance Preparation Package. Note: This feature is not intended for off-road usage. Placing objects on or over the airbag inflation area may cause those objects to be propelled by the airbag into your face and torso causing serious injury. Vehicle Curb Weight — is the weight of your new vehicle when you picked it up from your authorized dealer plus any aftermarket equipment.
Refer to Engine oil in the Maintenance and Specifications chapter. Refer to Heated and cooled seats in the Seating and Safety Restraints chapter for more information. Firmly press the two outer Car2U system buttons for 1—2 seconds, then release. Connect the positive + jumper cable to the positive + terminal of the discharged battery. Protect yourself from engine heat.
Wipe up spilled liquid using a clean, white, cotton cloth. Using your vehicle as an ambulance Do not use this vehicle as an ambulance. The tire suppliers may have additional markings, notes or warnings such as standard load, radial tubeless, etc. Once the disabled vehicle has been started, run both engines for an additional three minutes before disconnecting the jumper cables. Power recline if equipped Press the control to recline the seatback forward or rearward. Be sure to put the cap back on the reservoir. Use only Ford recommended replacement fasteners.
Make sure that your key is on and engine off while programming the transmitter. Do not use starting fluid such as ether in the air intake system. Our 2010 Ford F-150 repair manuals include all the information you need to repair or service your 2010 F-150, including diagnostic trouble codes, descriptions, probable causes, step-by-step routines, specifications, and a troubleshooting guide. Do not use your vehicle for snow removal until it has been driven at least 500 miles 800 km. . Otherwise, no recreational towing is permitted.
Find your 2010 Ford F-150 repair manual right now at Chilton. Start the engine of the disabled vehicle. Pull on the cable to align the components at the end of the cable. Install the bulb socket in lamp assembly by turning it clockwise. Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. Note: The interior lamps will turn off.
Refer to Maintenance product specifications and capacities in this chapter for the proper fluid type. These ratings are listed in the following chart. Repeat steps 4 and 5 until you are done changing the optional settings. Slide the latch at the bottom of the handle, then lower the handle. Unless serviced, the system may not function properly in the event of a collision. If you choose to install a remote start system please see your authorized dealer for a Ford approved remote start system. The Belt-Minder feature is activated and the vehicle speed is less than 3 mph.