Turn the ignition from the on to the off position. Apply the parking brake, turn the ignition to the off position, then remove the key. Step back while the pressure releases. Whenever possible it should be installed and properly adjusted when the seat is occupied. Automatic transmissions do not have push-start capability. Illumination after releasing the parking brake indicates low brake fluid level and the brake system should be inspected immediately by your authorized dealer. This message should disappear shortly.
Power recline if equipped Press the control to recline the seatback forward or rearward. Set the temperature to 60°F 16°C. Ask your fuel supplier about gasolines that meet the World-Wide Fuel Charter. If you buy your vehicle in North America and then relocate outside of the U. The oil from your hand could cause the bulb to break the next time the headlamps are operated.
Connect the two panels, then rotate both knobs a quarter-turn clockwise to secure the panels. Ford Motor Company recommends that the fuel system be inspected by an authorized dealer after any collision. Go to the front of the vehicle and release the auxiliary latch that is located on the front bumper under the grill. Regular maintenance or replacement is not needed. Department of Transportation requires Ford Motor Company to give you the following information about tire grades exactly as the government has written it. See Engine oil in the Maintenance and Specifications chapter for more information on oil usage. Connect the negative - cable to the negative - terminal of the assisting battery.
For more thorough cleaning, use a mild soap and water solution. See Warning lights and chimes in the Instrument Cluster chapter for more information regarding the warning lights. The child height, age and weight thresholds provided are recommendations or the minimum requirements of law. Red Candy Metallic Tinted Clearcoat Race Red 18-in. Vehicles shown may contain optional equipment.
When installing cleat, reverse instructions above. Deselect the autolamps after the desired autolamp delay time maximum of three minutes. Move the shift lever boot by pressing on the edges and moving it up the gearshift lever. Make sure the gearshift is in P Park. ® Lab tests ran it at full-boost for over 1,900 hours straight.
Do not use starting fluid such as ether in the air intake system. If you choose to install a remote start system please see your authorized dealer for a Ford approved remote start system. Use of these systems may result in vehicle starting problems and a loss of security protection. Refer to the Driving chapter for transmission function and operation. To unfasten, push the release button and remove the tongue from the buckle. Refer to Engine oil in the Maintenance and Specifications chapter.
If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount for towing to the nearest dealership within 35 miles 56 km. Failure to follow these instructions may interfere with the front passenger seat sensing system. Slide the latch at the bottom of the handle, then lower the handle. Ford Motor Company shall not be responsible for any such programming changes. The indicator light will begin to flash after 20 seconds. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a collision be replaced. Do not attach safety chains to the bumper.
. Pull on the cable to align the components at the end of the cable. The fuses are coded as follows. Each seat cushion can be flipped up into a vertical storage position. Set the fan to the highest blower setting. Visually inspect the tires to make sure there are no nails or other objects embedded that could poke a hole in the tire and cause an air leak.