Grasp the bulb only by its plastic base and do not touch the glass. Carefully pull the bulb straight out of the socket Install the new bulb s in reverse order. Slide the wheel partially under the vehicle and install the wire and retainer through the center of the wheel. Remove screw s from lamp assembly and disengage lamp assembly it has a snap fit. Install the new bulb s in reverse order.
Please contact your dealer for further information. Please make sure that you describe your difficulty with the Ford Ranger 2003 as precisely as you can. The doors will lock, then unlock, to confirm that the programming mode has been activated. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company.
Check your headlamp alignment at night or in a dark area so that you can see the headlamp beam pattern. We must all play our part, your vehicle does not need an extensive break-in, continuously at the same speed for the first 1,600 km 1,000 miles , drive your new vehicle at least 800 km 500 miles before towing. Park your vehicle on a level surface about 7. Not intended for use on dry pavement. Within 20 seconds press any button on the remote entry transmitter.
Information in this respect is highlighted in this guide with the tree symbol. Press and hold the bottom part of the rocker switch to open the window. Information related to engine, throttle, steering, brake other system, status potentially including information related how driver, operates the vehicle including but not limited vehicle speed, this information may be stored during regular operation or crash. When the highbeams are activated, the foglamps will not operate. Add enough fluid through the filler opening so that the fluid level is at the bottom of the opening. To stow the seat, fold seat back down and raise seat assembly to the fully upright position.
Introduction 7 Page: 7 These are some of the symbols you may see on your vehicle. Clock: Press and hold to set the clock. Fan speed adjustment: Controls the volume of air circulated in the vehicle. If equipped, unlock and remove the spare tire carrier lock from the rear access hole located just above the rear bumper and below the tailgate. A chime will also sound to remind you to fasten your safety belt. Shuffle: Press to play tracks in random order.
Four wheel drive high if equipped : Illuminates when four-wheel drive high is engaged. The tether strap may not work properly if attached somewhere other than the correct tether anchor. Do not park your vehicle in Neutral, it may move unexpectedly and injure someone. Remove the bulb retaining ring by rotating it counterclockwise and slide the ring off the plastic base. Use of these systems may result in vehicle starting problems and a loss of security protection.
The emission system heats up the engine compartment and exhaust system, which can start a fire. If brake fluid contacts the eyes, flush eyes with running water for 15 minutes. Any of this information could potentially include information regarding how the driver operates the vehicle potentially including but not limited to information regarding vehicle speed, brake or accelerator application or steering input. Rewind: Press for a slow rewind, press and hold for a fast rewind. The radio will resume playing. The Warranty Guide that is provided to you along with your Owner's, the computer in your vehicle is capable recording detailed data, potentially including but not limited information such as, information about the performance of various systems modules. Also, use the safety belt extension only if the safety belt is too short for you when fully extended.
Refer to Lubricant Specifications in this chapter. Direct the outer instrument panel vents towards the side windows To increase airflow to the outer instrument panel vents, close the vents located in the middle of the instrument panel. Do not place objects on top of the instrument panel as these objects may become projectiles in a collision or sudden stop. Release the steering wheel release control. See your dealer or trailer rental agency for proper instructions and equipment for hooking up trailer lamps. Such as, data discs containing no. Furthermore, due to printing cycles it may describe options before they are generally available.
If the needle falls below the normal range, stop the vehicle, turn off the engine and check the engine oil level. If the light is blinking, engine misfire is occurring which could damage your catalytic converter. Tune: Works in radio mode only. Make sure the locking clip screws are loose before removing the extender. Install the new bulb s in reverse order.
Snow tires must be the same size and grade as the tires you currently have on your vehicle. Automatic transmission fluid dipstick if equipped 3. Do not install a child seat in a center facing jump seat. Engine oil pressure gauge: Indicates engine oil pressure. Set the parking brake, depress the clutch and place the gearshift in N Neutral.